Interface_type property – MagTek USB MagnePrint Swipe Reader with Encryption User Manual
Page 44
USB MagnePrint Swipe Reader with Encryption
36
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
Example Set ASCII_TO_KEYPRESS_CONVERSION_TYPE property Request (Hex):
Cmd Num
Data Len
Prp ID
Prp Value
01 02
0F
00
Example Set ASCII_TO_KEYPRESS_CONVERSION_TYPE property Response (Hex):
Result Code Data Len
Data
00 00
Example Get ASCII_TO_KEYPRESS_CONVERSION_TYPE property Request (Hex):
Cmd Num
Data Len
Prp ID
00 01
0F
Example Get ASCII_TO_KEYPRESS_CONVERSION_TYPE property Response (Hex):
Result Code Data Len
Prp Value
00 01
00
INTERFACE_TYPE PROPERTY
Property ID:
16 (0x10)
Property Type:
Byte
Length: 1
byte
Get Property:
Yes
Set Property:
Yes
Default Value:
1 (keyboard emulation)
Description:
The value is a byte that represents the devices interface type. The value can
be set to 0 for the HID interface or to 1 for the Keyboard Emulation interface.
When the value is set to 0 (HID) the device will behave as described in the
HID manual. When the value is set to 1 (keyboard emulation) the device will
behave as described in the keyboard emulation manual. This property should
be the first property changed because it affects which other properties are
available. After this property is changed, the device should be power cycled
before changing any other properties.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled to have these changes take effect.
Example “Set INTERFACE_TYPE property to HID” Request (Hex):
Cmd Num
Data Len
Prp ID
Prp Value
01 02
10
00
Example Set INTERFACE_TYPE property Response (Hex):
Result Code Data Len
Data
00 00