MagTek USB MagnePrint Swipe Reader with Encryption - Manual (Page 34)

USB MagnePrint Swipe Reader with Encryption
26
Get Property Request Data:
Data Offset Value
0 Property ID
Get Property Response Data:
Data Offset Value
0 – n Property Value
Set Property Request Data:
Data Offset Value
0 Property ID
1 – n Property Value
Set Property Response Data:
None
The result codes for the Get and Set Property commands can be any of the codes list in the
generic result code table.
Property ID is a one-byte field that contains a value that identifies the property. The following
table lists all the current property ID values:
Value
HID
mode
Value
KB
mode
Property ID Description
0 0 SOFTWARE_ID The device’s software identifier
1 1 SERIAL_NUM The device’s serial number
2 2 POLLING_INTERVAL The interrupt pipe’s polling interval
3 - MAX_PACKET_SIZE The interrupt pipe’s packet size
4 3 TRACK_ID_ENABLE Track enable / ID enable
- 4 TRACK_DATA_SEND_FLAGS Track data send flags
- 5 TERMINATION_CHAR Terminating char / per track or card flag
- 6 SS_TK2_7BITS Start sentinel char for track 2 – 7 bit data
- 7 Reserved for future use
- 8 SS_TK3_ISO_ABA Start sentinel char for track 3 – ISO/ABA
- 9 SS_TK3_AAMVA Start sentinel char for track 3 - AAMVA
- 10 SS_TK3_7BITS Start sentinel char for track 3 – 7 bit data
- 11 PRE_CARD_CHAR Pre card char
- 12 POST_CARD_CHAR Post card char
- 13 PRE_TK_CHAR Pre track char
- 14 POST_TK_CHAR Post track char
- 15 ASCII_TO_KEYPRESS_CONV
ERSION_TYPE Type of conversion performed when
converting ASCII data to key strokes
16 16 INTERFACE_TYPE Type of USB interface
- 17 ACTIVE_KEYMAP Selects which key map to uses
- 18 PRE_CARD_STRING Pre card string
- 19 POST_CARD_STRING Post card string
- 20 SS_TK1_ISO_ABA Start sentinel char for track 1 – ISO/ABA
- 21 SS_TK2_ISO_ABA Start sentinel char for track 2 – ISO/ABA
- 22 ES End sentinel char for all tracks/formats
- 35 FS Field Separator for additional data