Videotec PTH355P - Manual (Page 23)

Pag. 7 MNPTH3553803
Pan & tilt connection to control units
In the following drawing, identify the terminal block J1 in the lower printed circuit for the pan & tilt connection to
the control units:
Pan & tilt connection to DTRXDC receiver
Where to operate: J1 terminal block in the upper printed circuit of the pan & tilt motor (see drawing), J1 terminal block
of the receiver (see DTRXDC manual)
Adjustments: connect the terminal block J1 of the pan & tilt motor to that of the receiver according to the following
table
Terminal block J1 of DTRXDC Terminal block J1 (Pan & Tilt)
PAN + Pan +
PAN - Pan -
TILT + Tilt +
TILT - Tilt -
Preset connection to DTRXDC receiver
Where to operate: J4 terminal block in the upper printed circuit of the pan & tilt motor, J3 terminal block of receiver
(see DTRXDC manual)
Adjustments: connect the J4 terminal block of the pan & tilt motor to the terminal block of the receiver according to the
following table:
Terminal block J3 of DTRXDC Meaning Terminal block J4 (Pan & Tilt)
Vcc +5 Volt Vcc
Pan Horizontal Pan
Tilt Vertical Tilt
Gnd 0 Volt Gnd