Videotec HGV - Manual (Page 6)

EN - English - I
nstruc
tions manual
4
5 Preparing the
product for use
h Any change that is not expressly
approved by the manufacturer
will invalidate the guarantee.
5.1 Contents and unpacking
When the product is delivered, make sure that
the package is intact and that there are no
signs that it has been dropped or scratched.
If there are obvious signs of damage,
contact the supplier immediately.
Keep the packaging in case you need
to send the product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• Housing
• Housing equipment:
• Wiper blade
• Plate with nozzle for wiper
• Stainless steel plate without holes
for cable glands/connectors
• Bracket for mounting lenses and cameras
• Stainless steel washers and screws
• Nylon spacers for camera and lens
• Galvanised plate spacer, 20mm-high
• Nylon washers
• 1/4" screw for lens and camera
• Allen key
• Silica gel sachet
• Instructions manual
5.2 Safely disposing of
packaging material
The packaging material can all be recycled.
The installer technician will be responsible for
separating the material for disposal, and in
any case for compliance with the legislation
in force where the device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging
for its transport is strongly recommended.
4 Identification
4.1 Product description
and type designation
Large-size housing, designed to allow mounting of
the largest "zoom cctv lenses" on the market; for
example PENTAX 55x, FUJINON 60x, PENTAX 18x,
COMPUTAR 30x, COMPUTAR 50x … and many others.
Its water-tightness is assured by the neoprene
rubber gaskets, by 4 M16 cable glands equipped
with relative gaskets and by the stainless steel
screws that guarantee its permanent closure.
It is made up by a shell-cast aluminium base,
epoxypolyester powder painted, and by an
upper casing with integrated sunshield in ABS
PMMA plastic material, colour RAL9002.
The housing is supplied with incorporated
wiper which doesn’t interfere with the field
of vision of the lens-camera installed.
The ideal inner temperature is assured
by enhanced heating and by service
fans for continual air re-circulation.
The assembling and adjustment of the lenses-
cameras are facilitated by the possibility of extracting
the upper casing with integrated sunshield and to
leave them hanging from the sturdy anchoring cable.
The HGV housing is ideal for outdoor applications,
as in the case of fire monitoring, public security,
harbours, coastlines, airports, environmental
monitoring and border surveillance.
4.2 Product markings
See the label attached to the outside of the package.