Videotec PUNTO HI-PoE - Manual (Page 6)

EN - English - I
nstruc
tions manual
4 MNVCHEEPOE_1407_EN
• This device was designed to be permanently
installed on a building or on a suitable structure.
The device must be installed permanently before
any operation.
• When installing the device, comply with all the
national standards.
• Any device which could be installed inside the
product must comply with the current safety
standards.
• For all connections, use cables that are able to
withstand temperatures of at least 75°C (167°F).
• Power supply to the product must be exclusively
provided by the PoE cable (Power over Ethernet).
• Use power supplies compliant with regulations
IEEE 802.3at/af and 60950-1.
• The product must be fastened with suitable
equipment. The fastening means must guarantee
the mechanical seal when a force equal to at least
4 times the weight of the device is applied.
4 Identification
4.1 Product description and type
designation
The PUNTO Hi-PoE housing exploits the PoE and Hi-
PoE technology in an optimal way, using the power
provided by the Ethernet cable as the sole source of
electricity to power the network camera along with
heating/demisting.
PUNTO Hi-PoE provides high reliability and flexibility
of the network installation and simplifies installation
operations with important cost reduction.
PUNTO Hi-PoE can be configured via a dip switch
according to the PoE or Hi-PoE standards depending
to the system requirements.
Very easy to install thanks to the side opening system
that allows the full access to the camera, lenses and
all internal connections.
The front is designed to offer protection from UV rays
and atmospheric agents.
4.2 Product markings
See the label attached to the product.