ATEN CS-1754 User Manual
Page 13
1. Introduction
5
No.
Component
Description
1
Port Selection
Switches
Press a switch to access the computer attached to its
corresponding port.
Pressing buttons 1 and 2 simultaneously for 2 seconds
performs a keyboard and mouse reset.
For the CS-1754, pressing buttons 3 and 4
simultaneously for 2 seconds starts Auto Scan Mode; for
the CS-1758, pressing buttons 7 and 8 simultaneously
for 2 seconds starts Auto Scan Mode. See Auto Scan
Mode, page 36, for details.
2
Port LEDs
The Port LEDs are built into the Port Selection Switches.
The upper ones are the On Line LEDs; the lower ones are
the Selected Port LEDs:
The On Line LEDs light ORANGE to indicate that the
computer attached to its corresponding port is up and
running. If the LED is flashing, it indicates that the Port is
being used for cascading to another Master View switch
(see Two Stage Installation, page 14).
The Selected LEDs light GREEN to indicate that the
computer attached to its corresponding port is the one
that has the KVM focus. The LED is steady under
normal conditions, but flashes when its port is accessed
under Auto Scan Mode (see Auto Scan Mode, page 36,
and F7 SCAN, page 32).
3
Reset Switch
Pressing this switch in for less than three seconds
performs a warm reset.
Pressing this switch in for more than three seconds
performs a cold reset.
Note: The switch is recessed and must be pushed with a
thin object - such as the end of a paper clip, or a ball point
pen.
4
Power LED
The Power LED lights to indicate that the CS-1758 is
powered up and ready to operate.
cs1754-1758.book Page 5 Friday, July 20, 2007 10:06 AM