Kenwood NX-300SE - Manual (Page 32)

21
‡ (QWHUD)OHHWQXPEHUWRPDNHDFDOOWRDOOXQLWVLQWKHVHOHFWHG
ÁHHW)OHHWFDOO
‡ (QWHUDQ,'QXPEHUWRPDNHDFDOOWRWKHVHOHFWHG,'LQDOO
ÁHHWV6XSHUYLVRUFDOO
• Select “ALL” Fleet and “ALL” ID to make a call to all units
%URDGFDVWFDOO
STATUS MESSAGE
be decided in your talk group. Messages can contain up to 16
DOSKDQXPHULFFKDUDFWHUV6WDWXVPHVVDJHVUDQJHIURPWR
aDUHUHVHUYHGIRUVSHFLDOPHVVDJHV
$PD[LPXPRIUHFHLYHGPHVVDJHVFRPELQHGVWDWXV
PHVVDJHVDQGVKRUWPHVVDJHVFDQEHVWRUHGLQWKHVWDFN
memory of your transceiver.
Q Transmitting
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter Status
PRGHSURFHHGWRVWHSRUSelcall + Status to enter
6HOFDOOPRGHSURFHHGWRVWHS
3 Press WRVHOHFWWKHVWDWLRQ\RXZDQWWRFDOO
• If Manual Dialing is enabled, you can enter a station ID
by using the DTMF keypad, or by using
. When
using , cycle through the digits to select a digit,
then press to set the digit and move the cursor to the
right. Repeat this process until the entire ID is entered.
4 Press to enter Status mode.
5 Press WRVHOHFWWKHVWDWXV\RXZDQWWRWUDQVPLW
• If Manual Dialing is enabled, you can enter a status ID by
using the DTMF keypad, or by using
UHIHUWR
VWHSDERYH
6 Press the PTT VZLWFKRUSide 2 key to initiate the call.
‡ ´&203/(7(!µDSSHDUVRQWKHGLVSOD\ZKHQWKHVWDWXV
has been successfully transmitted.