Kenwood NX-300SE - Manual (Page 29)

SCAN
Scan monitors for signals on the transceiver channels. While
scanning, the transceiver checks for a signal on each channel
and only stops if a signal is present.
To begin scanning, press the key programmed as Scan.
• The LFRQDSSHDUVRQWKHGLVSOD\1;1;2QO\
‡ 7KH/('EOLQNVJUHHQ1;61;62QO\
• When a signal is detected on a channel, Scan pauses at that
FKDQQHO7KHWUDQVFHLYHUZLOOUHPDLQRQWKHEXV\FKDQQHOXQWLOWKH
VLJQDOLVQRORQJHUSUHVHQWDWZKLFKWLPH6FDQUHVXPHV
To stop scanning, press the Scan key again.
Note: To use Scan, there must be at least 2 channels in the scan
sequence.
TEMPORARY CHANNEL LOCKOUT
'XULQJVFDQ\RXFDQWHPSRUDULO\UHPRYHVSHFLÀFFKDQQHOV
from the scanning sequence by selecting them and pressing
the key programmed as Scan Delete/Add.
‡ 7KHFKDQQHOLVQRORQJHUVFDQQHG+RZHYHUZKHQVFDQQLQJLV
ended and restarted, the channels are reset and deleted channels
ZLOODJDLQEHLQWKHVFDQQLQJVHTXHQFH
PRIORITY SCAN
Note: To use Priority Scan, a Priority channel must be programmed.
:KHQXVLQJDVLQJOH3ULRULW\FKDQQHOWKHWUDQVFHLYHUZLOO
DXWRPDWLFDOO\FKDQJHWRWKH3ULRULW\FKDQQHOZKHQDFDOOLV
received on that channel, even if a call is being received on a
normal channel.
When using dual Priority channels, Priority channel 1 is given
precedence over Priority channel 2. So, if a call is received on
3ULRULW\FKDQQHOZKLOHDFDOOLVDOUHDG\RQ3ULRULW\FKDQQHO
WKHWUDQVFHLYHUZLOOFKDQJHWR3ULRULW\FKDQQHO