Kenwood NX-300SE - Manual (Page 14)

'RQRWXVHJOXHZKLFKLVGHVLJQHGWRSUHYHQWVFUHZORRVHQLQJZKHQ
LQVWDOOLQJWKHEHOWFOLS$FU\OLFHVWHUZKLFKLVFRQWDLQHGLQWKHVH
glues, may crack the transceiver’s back panel.
INSTALLING THE CAP OVER THE UNIVERSAL CONNECTOR
INSTALLING THE BELT CLIP
Attach the belt clip using the
VXSSOLHG[PPVFUHZV
Note: If the belt clip is not
installed, its mounting location
may get hot during continuous
WUDQVPLVVLRQRUZKHQOHIWVLWWLQJLQ
a hot environment.
Insert the cap into place over the
universal connector and secure
it in place using the attached
VFUHZ
INSTALLING THE (OPTIONAL) SPEAKER/ MICROPHONE OR
HEADSET
1 Insert the guide of the
VSHDNHUPLFURSKRQHRU
headset connector into place
over the universal connector.
2 Secure the connector in place
XVLQJWKHDWWDFKHGVFUHZ
Note: When not using an optional
VSHDNHUPLFURSKRQHRUKHDGVHW
install the cap over the universal
connector.
3 x 8 mm screws
Belt clip
Universal
connector cap
MIC
1
2A BC
5JK L
0
8 TU V
4
7 GH I PQ RS 3 DEF
6 MNO
MIC
#
9 WXYZ
Optional
speaker/ microphone