Kenwood NX-300SE User Manual
Page 10
vii
•
Do not charge the battery near fires or under direct
sunlight!
If the battery’s protection circuit is damaged, the battery may
charge at extreme current (or voltage) and an abnormal
chemical reaction may occur. The battery may generate heat or
VPRNHUXSWXUHRUEXUVWLQWRÁDPH
•
Use only the specified charger and observe charging
requirements!
,IWKHEDWWHU\LVFKDUJHGLQXQVSHFLÀHGFRQGLWLRQVXQGHUKLJK
temperature over the regulated value, excessive high voltage
or current over regulated value, or with a remodelled charger),
it may overcharge or an abnormal chemical reaction may occur.
The battery may generate heat or smoke, rupture, or burst into
ÁDPH
•
Do not pierce the battery with any object, strike it with an
instrument, or step on it!
This may break or deform the battery, causing a short-circuit.
The battery may generate heat or smoke, rupture, or burst into
ÁDPH
•
Do not jar or throw the battery!
An impact may cause the battery to leak, generate heat
RUVPRNHUXSWXUHDQGRUEXUVWLQWRÁDPH,IWKHEDWWHU\ҋV
protection circuit is damaged, the battery may charge at an
abnormal current (or voltage), and an abnormal chemical
reaction may occur.
•
Do not use the battery pack if it is damaged in any way!
The battery may generate heat or smoke, rupture, or burst into
ÁDPH
•
Do not solder directly onto the battery!
If the insulator is melted or the gas release vent or safety
function is damaged, the battery may generate heat or smoke,
UXSWXUHRUEXUVWLQWRÁDPH
•
Do not reverse the battery polarity (and terminals)!
When charging a reversed battery, an abnormal chemical
reaction may occur. In some cases, an unexpected large
DPRXQWRIFXUUHQWPD\ÁRZXSRQGLVFKDUJLQJ7KHEDWWHU\PD\
JHQHUDWHKHDWRUVPRNHUXSWXUHRUEXUVWLQWRÁDPH