AMD N2PAP-LITE - Manual (Page 35)

32
3-11 Miscellaneous Control
This section provides options for setting CPU Frequency/Voltage Control.
CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
Miscellaneous Control
Item Help
** Current Host Clock is
Host Clock at Next Boot is 100MHz
** Current DRAM Clock is
DRAM Clock at next Boot is 133MHz
CPU Ratio Select Default
Core_VDD Select 1.7V(Default)
VDD_AUXC Select 1.6V(Default)
VAGP Output 1.5V(Default)
VRAM Output 2.6V(Default)
VAUX Output Default
VTT Voltage 1.25V
VAGP LUV Protect Enabled
VRAM LUV Protect Enabled
Dual3.3V LUV Protect Disabled
Flash Parts Write Protect Enabled
Menu Level >
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
Host Clock at next Boot is
This item allows you to select CPU frequency at preset values.
The choices are: 100MHz, 133MHz, 166MHz, 200MHz, 236MHz, 240MHz, 242MHz, 244MHz,
245MHz, 250MHz
DRAM Clock at next Boot is
This field supports the capability of setting the memory modules clocks that you can use.
The choice is either 100MHz, 110MHz, 125MHz, 133MHz, 138MHz, 166MHz, 200MHz, 208MHz,
221MHz, 249MHz
CPU Ratio Select
This item allows you to select Ratio of the CPU. The choice are:X5~X24
VDD AUXC Select
This item allows you to select Chip Voltage. The choice are 1.6V(Default), 1.7V
VAGP Output
This item allows you to select 1.5V voltage of the AGP VGA card. The choice are: 1.5V,
1.6V,1.7V
VRAM Output
This item allows you to select 2.5V of the DDR Module. The choice are: 2.5V~ 3.0V.
VAUX Output
This item allows you to select AUX voltage. The choice are: Default, 2%, 4%, 8%,12%, 16%.
VTT Voltage
This item allows you to select VTT voltage. The choice are: 1.25V, VDIMM/2.
VAGP/VRAM LUV Protect
This item allows you to enable the protective function on motherboard when over current presents.
The choice are: Enabled(Default), Disabled
Flash Parts Write Protect
This item allows you to protect BIOS against the data crash of virus. The choice are: Enabled,
Disabled. Before flash BIOS you have to change the setting to Disabled, otherwise you can not flash
BIOS.