AMD N2PAP-LITE - Manual (Page 33)

30
Normally, this field is set Disabled. If you have installed a new add-on and the system
reconfiguration has caused a serious conflict resulting in the operating system boot failure,
select Enabled to reset Extended System Configuration Data (ESCD) when you exit Setup.
The settings are: Enabled and Disabled.
Resource Controlled By
The Award Plug and Play BIOS has the capability to configure all of the boot and Plug and
Play compatible devices automatically. However, this capability means absolutely nothing
unless you are using a Plug and Play operating system, such as Windows®95/98. If you set
this field to “manual”, choose specific resources by going into each of the sub menu that
follows this field (a sub menu is preceded by a “>”).
The settings are: Auto(ESCD), Manual.
IRQ Resources
When resources are controlled manually, assign each system interrupt a type, depending on
the type of device using the interrupt.
Please refer to section 3-9-1
PCI/VGA Palette Snoop
Leave this field at Disabled. The settings are Enabled, Disabled.
3-9-1 IRQ Resources
CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
IRQ Resources
Item Help
IRQ3 assigned to PCI Device
IRQ4 assigned to PCI Device
IRQ5 assigned to PCI Device
IRQ7 assigned to PCI Device
IRQ9 assigned to PCI Device
IRQ10 assigned to PCI Device
IRQ11 assigned to PCI Device
IRQ12 assigned to PCI Device
IRQ14 assigned to PCI Device
IRQ15 assigned to PCI Device
Menu Level >>
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults