AMD N2PAP-LITE - Manual (Page 12)

9
Overheat Protect: Only for Athlon XP series CPU, when the CPU is overheated, system will
automatically shut down power supply. You can hear a continue beep sound, the
power button will be locked up. You must turn off and turn on the AC power to
reset the system. Otherwise, the power button will not function. The other way
is to keep pressing the button for a few seconds till the beep sound stops. Then,
release the power button and press the power button again to turn on the power
supply.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF socket
and open it by first pulling the lever sideways away from the socket and lift the lever
upward to a 90-degree angle. Insert the CPU with the correct orientation as shown below.
The notched corner should be pointed toward the end of the lever. The CPU has corner pin
on two of the four corners and the CPU will only fit in the orientation as shown.
CPU ZIF Socket-A
Colden Arrow
Socket 462
When you insert the CPU onto the ZIF socket, no force is required. After inserting, press
the lever slightly without any extra force to lock CPU in position.
2-4 Install Memory
This motherboard provides two 184-pin DUAL INLINE MEMORY MODULES (DIMM)
sockets for memory expansion from a minimum memory size of 64MB to maximum
memory size of 2.0GB DDR SDRAM.
Valid Memory Configurations
Bank 184-Pin DIMM PCS Total Memory
Bank 0, 1 (DIMM1) DDR 266/333/400 DDR SDRAM X1 64MB∼1.0GB
Bank 2, 3 (DIMM2) DDR 266/333/400 DDR SDRAM X1 64MB∼1.0GB
Total System Memory (Max. 2.0GB) 2 64MB∼2.0GB
NOTE! Make sure the total installed memory size does not exceeds 2.0GB. Otherwise,
the system may hang during startup.
Generally, installing DDR SDRAM modules to the motherboard is very straightforward.
Please refer to figure 2-4 for the detail of 184-Pin
DDR 266/333/400 DDR SDRAM module
and the socket.