Light (led), Tips for saving energy, If required, use an insulating plate – Siemens GS36NBI30 User Manual
Page 33: Open the appliance as briefly as possible, Operating noises, Quite normal noises, Droning, Bubbling, humming or gurgling noises, Clicking, Preventing noises
en
33
Light (LED)
Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.
Tips for saving energy
■
Install the appliance in a dry, well
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
■
Do not block the ventilation openings
in the appliance.
■
Allow warm food and drinks to cool
down before placing in the appliance.
■
Thaw frozen food in the refrigerator
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
■
Open the appliance as briefly as
possible.
■
Ensure that the freezer compartment
door is always closed properly.
■
Occasionally clean the rear
of the appliance to prevent an
increased power consumption.
■
If available:
Fit wall spacers to obtain the indicated
energy rating of the appliance (see
Installation instructions). A reduced
wall gap will not restrict the function
of the appliance. The energy rating
may then increase slightly. The gap
of 75 mm must not be exceeded.
■
The arrangement of the fittings does
not affect the energy rating of the
appliance.
Operating noises
Quite normal noises
Droning
Motors are running (e.g. refrigerating
units, fan).
Bubbling, humming or gurgling noises
Refrigerant is flowing through the tubing.
Clicking
Motor, switches or solenoid valves are
switching on/off.
Preventing noises
The appliance is not level
Please align the appliance with a spirit
level. Use the height-adjustable feet
or place packing underneath them.
The appliance is not free-standing
Please move the appliance away
from adjacent units or appliances.
Containers or storage areas wobble
or stick
Please check the removable parts
and re-insert them correctly if required.