Siemens HF25M5L2 - Manual (Page 26)

26
Problem Remedial action/notes Possible cause
A signal sounds. The two dots in
the display are flashing.
The appliance is in
demonstration mode.
1. Press the 2 button.
2. Press and hold the g button
for 3 seconds.
The demonstration mode is
deactivated.
The appliance switches off shortly
after starting. Error message "H95"
appears in the display.
The door is not properly closed. Open the door again and close
it properly, if this does not help,
contact the afterĆsales service.
Error message "E723" appears in
the display.
The door is not properly closed. Open and close the appliance
with the 3 button.
Error message "Er1" appears in the
display.
The temperature sensor is
faulty.
Call the afterĆsales service.
Error message "Er11" appears in
the display. "Button is jammed"
The buttons are dirty or the
mechanics have jammed.
Press all the buttons several
times. Clean the buttons with a
dry cloth. Open and close the
appliance door. If this does not
help, consult the afterĆsales
service.
Error message "Er4" appears in the
display.
There is extreme overheating
(possibly a fire inside).
Microwave power setting too
high.
Do not open the door.
Disconnect from the mains or
switch off the fuse in the fuse
box and allow to cool down.
Error message "Er18" appears in
the display.
Technical fault. Call the afterĆsales service.
Risk of electric shock.
Incorrect repairs are dangerous. Repairs may only be
carried out by one of our trained afterĆsales engineers.
d