Hydraulic generator controller – hgc-2 – High Country Tek HGC-2, Closed Loop Controller User Manual

Page 2

Hydraulic Generator Controller – HGC-2

This product has been designed to interface directly with any manufacturers range of proportional pressure
and/or flow control valves, variable pumps, motors and manifold blocks currently available.

Please contact the factory by the e-mail address given below or nearest High Country Tek, Inc. distributor for
further technical information and availability.

• Controller Module :-………………………………………….………… See rear of manual for ordering info.

• Controller Graphical User Interface ( GUI ):-………………………. P/No: 023-00228

• HGC2 controller software CD:-………………….……….………...... Contact HCT customer service for info

• Controller info manual:-……………………………………………….. P/No: 021-00160

• Programming Cable:-…………….……………………………………. P/No: 999-10166

• HGC-2, 8-pin Connector Kit:-…………..……..………………………. P/No: 999-10073

IMPORTANT NOTE:-

High Country Tek, Inc. reserves the right to upgrade, revise or better any controller as technology improves without notice being given.

Wherever possible, full downwards compatibility for both hardware and software on replaced controllers will be maintained but it is the users
responsibility to ensure that the latest technical details or literature is being used for application reference.

If you are unsure of the literature, hardware or software revisions you have, or suspect that it is an older revision, please send an e-mail request for
the latest releases to [email protected]

Important Notes

System Part Numbers:

Application Limitations:

High Country Tek, Inc. (HCT) designs and supplies products specifically for use in commercial, industrial and
mobile control applications with products only warranted for this type of use. HCT distributors are not authorized to
approve the use of any HCT product in any of the following applications:

• Any product that comes under the Federal Highway Safety Act, i.e., steering/braking systems for passenger
carrying vehicles or on-highway

• Aircraft ( private, military, commercial or other ) or space vehicles.

• Ordnance equipment ( fixed or mobile ).

• Any end product that, when sold, comes under the U.S. Nuclear Regulatory Commission rules and regulations.

Specific written approval for any application of HCT products in any of the above named applications should be
obtained from High Country Tek, Inc and consultation with our factory engineers is advised in unusual situations
where applicability is questionable.