High Country Tek HFS - Manual (Page 19)

Hydraulic Fan System Controller: HFS
At the observer level, I/O Display, Help and Quit is the only
options available on the menu bar.
1
Alarm and Error text window.
Error messages are in RED text.
The window stays as above while there are no errors or
alarms reported by the system and/or controller.
2
Window where ‘Real-time’ graphing of selected parameter
in is displayed. 3
5
Drop down list of available parameters for display.
5
Digital representation of the parameter being displayed in
6
Selects Slow, Medium or Fast graph time base setting.
7
Selects Graphic window scaling between FULL scale or
AUTO. Auto gives better resolution for lower values.
8
General display area for controller information and input /
output status. 9
Analogue needle display and digital readout of ‘real-time’
output current to proportional valve drive. 10
Analogue bar graph and digital readout of ‘real-time’ output
current as a % of the maximum set. 11
Clicking the HCT logo, prompts the user for the password
level required:-
12
12
7
12
9
11
Software Set-Up Guide ( Dashboard ):
19
1
2
4
5
10
4
6
Real time graphing window 4
7
8
9
11
12
• When the HCT logo is clicked, this window will
open and reset the access level to NONE.
• You must enter a password to enter a new level.