High Country Tek HFS - Manual (Page 15)

Hydraulic Fan System Controller: HFS
The ‘FILE’ tab brings the ‘SAVE’ and ‘RESTORE’ options to the user.
SAVE:
Temporary Memory -> Permanent Memory:- transfers all data
from PC to the connected module for onward unattended
operation at the current profile settings ONLY. NO backup copy
is made !
Temporary Memory -> Permanent Memory & File:- transfers
all data from PC to the connected module for onward
unattended operation at the current profile settings ONLY.
Opens window to allow user to select stored file name and
location for backup copy of profile.
RESTORE:
Permanent Memory -> Temporary Memory:- transfers all data
from the connected module to the PC for editing the current
profile being used.
File -> Permanent and Temporary Memory:- transfers all data
from a hard copy PC file to the connected module and onto the
PC for editing.
Software Set-Up Guide ( Menu Bar ):
15
For added system security, as soon as the Opto 3000 recognizes that
the user has connected any powered High Country Tek controller unit,
it requests the modules identity to compare to information stored in
the graphical user interface. If this identity does NOT match the
expected information, the program will display the message seen to
the right to inform the user that the unit is not the one anticipated.
If the module sends the correct identification to the program, the user
is allowed to enter passwords and operate the software as normal.
Saving / Restoring Profile data file
The GUI software and module allows the user to set–up and optimize the units characteristics as required and then
save the profile as a backup or for future download into new modules so that they are all set identically.
This feature should be used to save a backup copy for operational security.
Below are the options available to the user.
Please contact HCT customer support for details on how you can request an optimized file you have developed and
saved to be pre-loaded into a controller for your application by the factory.