AMETEK 955DQ Brik LDT - Manual (Page 2)

2 1080 N. Crooks Road • Clawson, MI 48017 • 800.635.0289 • 248.435.0700 • Fax 248.435.8120 • www.AMETEKAPT.com
Preface
This manual is divided into three chapters. Chapter 1
provides the hardware overview for the 955DQ Linear
Displacement Transducers (LDT). Chapter 2 provides
instructions for installing the LDT to a mounting bracket.
Chapter 3 provides an overview and wiring instructions.
To further assist you, a glossary is provided at the back of
the manual.
CAUTION
!
Disconnect Power Before Servicing. The
Gemco 955DQ LDT Contains No Serviceable
Components. Consult Factory for Repair or
Replacement.
AMETEK Automation & Process Technologies has
checked the accuracy of this manual at the time it was
approved for printing. However, this manual may not
provide all possible ways of installing and maintaining
the LDT. Any errors found in this manual or additional
possibilities to the installation and maintenance of
the LDT will be added in subsequent editions. Any
comments you may have for the improvement of this
manual are welcomed.
AMETEK reserves the right to revise and redistribute
the entire contents or selected pages of this manual.
All rights to the contents of this manual are reserved
by AMETEK. The BRIK is a registered trademark of
AMETEK.