HighPoint RocketRAID 3510 - Manual (Page 44)

Web RAID Management Interface
5-7
B) You cannot change an array to another type of array with a smaller capacity. In some
cases, a disk may need to be added to the RocketRAID card.
During the OCE/ORLM procedure, the redundancy level of the array will be the lowest
of the source and target arrays; e.g. if you ORLM a RAID0 array to a RAID1 array, the
array will be non-redundant until the procedure is complete.
C) The OCE/ORLM process can be aborted and continued at later time. However, you
should always stop the transform progress from the RAID Management software.
An unexpected system crash may result in data loss while performing OCE/ORLM on an
array. We strongly recommend backing up data before starting the OCE/ORLM process.
After the OCE/ORLM procedure has completed, reboot the system.
Other RAID related Functions
Renaming an Array
You are free to rename RAID arrays. This will not harm the array – data will not be lost.
To rename an array:
1) Select “ Manage - Array ” from the menu.
2) Highlight the desired RAID array
3) Click on the “ Maintenance ” button.
4) Enter a new name for the array in the provided field.
5) Click the “ Rename ” button.
Note: An array running background tasks cannot be renamed.
Unplug
This can be used to safely take an entire array offline while the system remains operational.
To Unplug an array:
1) Select “ Manage - Array ” from the menu.
2) Highlight the desired RAID array
3) Click on the “ Maintenance ” button.
4) Click the “ Unplug ” button.
5) The software will notify you when it is safe to remove the array.
Note: Make sure the array is not in use before using this command. Active arrays
cannot be unplugged.
4 Device Management
Select the “ Manage - Device ” function to access the device management page.