HighPoint RocketRAID 3510 - Manual (Page 34)

RocketRAID 3xxx Driver and Software Installation
4-3
2. Select the desired software from the drop down menu, and click on the “OK”
button.
Windows Driver Installation
Before installing the RocketRAID 3xxx device driver, make sure the RocketRAID 3xxx
host adapter and all required hard disks have been installed into the system’s chassis
(refer to the Hardware Installation section).
Installing the RocketRAID 3xxx driver for an existing Windows XP/
2003/x64 system
After the operating system has booted, Windows will automatically detect the
RocketRAID 3xxx, and request that a device driver be installed. To install the device
driver, follow the steps outlined below:
1. When the “Found New Hardware Wizard” window appears, select “Install from a
list or specific location (Advanced)”, and click Next to continue.
2. Click on the “Include this location in the search” option, and select the system’s
floppy drive (generally Disk A). Next, insert the Driver Installation diskette into
the system’s floppy drive.
3. At the Hardware Wizard screen, select the floppy drive as the source, then click
the Next button. Select the appropriate operating system folder, then, click the
Next button.
4. Windows might display a warning message that states the driver has “not been
signed”. Select “Continue Anyway”, then, click Finish when prompted. When
Windows asks to reboot the system, choose No.
5. Remove the Driver Installation diskette from the floppy drive.
Installation Verification
After the driver has been installed, and the system has been restarted:
1. Click the Start button, select “Settings”, then select “Control panel”, double click
“System” item.
2. In the popup window, select Hardware tab and then click Device Manager button.