HighPoint RocketRAID 3510 User Manual
Page 26
RocketRAID 3xxx BIOS Utility
3-3
disk to system BIOS, “disable” register all logical disks to system BIOS.
INT 13 Support – This setting is enabled by default. Disabling this setting
will disable the RocketRAID 3xxx’s bootable support. The motherboard
should no longer treat the host adapter as a bootable device.
Stop on Error – This setting is enabled by default. Disabling this option will
prompt the RocketRAID 3xxx to automatically skip error messages during
bootup (broken array warnings), if the administrator does not input the
“Control + H” command to access the BIOS menu.
View
– this command is used to view information about the RocketRAID 3xxx, and
devices attached to it..
Devices – displays information about hard disks attached to the
RocketRAID 3xxx. Use the
↑
↓
arrow keys to highlight the target hard disk,
and press ENTER to view the information.
RAID Array – displays information about RAID arrays attached to the
RocketRAID 3xxx. Use the
↑
↓
arrow keys to highlight the target array, and
press ENTER to view the information.
Controller – displays information about the RocketRAID 3xxx, including the
card model, firmware revision, onboard memory, PCI slot location and BBU
(Battery Backup Unit) information if BBU is installed.
Rescan Devices – This option will rescan all of the physical devices at-
tached to the RAID controller.
Initialize
- this function is used to prepare disks for use with RAID arrays.
Note: Arrays cannot be created between disks that have not been initialized.
The following section discusses this command in detail.