Vaisala FD12P - Manual (Page 15)

Chapter 1 _________________________________________________________ General Information
VAISALA ________________________________________________________________________ 15
CAUTION The component boards including CMOS microchips should be
transported and stored in conductive packages. Although new CMOS
devices are protected against overvoltage damages caused by static
electric discharge of the operator, careful handling is recommended:
the operator should be properly grounded. Unnecessary handling of
component boards should be avoided.
Radio Frequency Interference Statement (USA)
The United States Federal Communications Commission (in 47 CFR
15.838) has specified that the following notice must be brought to the
attention of users of this kind of a product in the USA:
Federal communications commission radio frequency interference
statement
This equipment generates and uses radio frequency energy and if not
installed and used properly, that is in strict accordance with the
manufacturer's instructions, may cause interference to radio and
television reception. The Weather Sensor is designed to provide
reasonable protection against such interference in an airport
installation. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment causes
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- reorient the receiving antenna
- relocate this device with respect to the receiver
- move this device away from the receiver
If necessary, the user should consult the dealer or an experienced
radio/television technician for additional suggestions.
ESD Protection
Electrostatic Discharge (ESD) can cause immediate or latent damage
to electronic circuits. Vaisala products are adequately protected
against ESD for their intended use. However, it is possible to damage
the product by delivering electrostatic discharges when touching,
removing, or inserting any objects inside the equipment housing.