Outback Power Systems FLEXnet DC Users Guide - Manual (Page 25)

24
Shunt 1 is, by default, enabled or active when the FX is
powered up. Pressing the soft key disables the fi rst
shunt. Pressing the soft key leads to the shunt 2
mode and shunt 3 mode screens. These shunts are disabled
at power-up and are enabled by pressing the soft key.
When the setup for all shunts has been completed, press the
soft key for the next screen.
ADV/DC/SHUNT 1 ---------------
shunt 1 mode
DOWN EN DIS TOP
Press the soft key.
ADV/DC/PAGE 1----------------
choose category
ADV BAT SHUNT PG2
ADV/DC/SHUNT-----------------
shunt setup complete
TOP ADV MAIN
Use the battery capacity screen to set the battery bank
capacity using either the or soft key. When
fi nished, press the soft key.
ADV/DC/BAT-------------------
battery capacity
amp hours
TOP INC DEC ADV
Press the soft key.
ADV/DC/PAGE 1----------------
choose category
ADV BAT SHUNT PG2
Pressing the soft key
changes the shunt being enabled
or disabled.
Press the soft key.
Press the soft key.
ADV--------------------------------
choose device:
FX CC DC MATE
Press the soft key.
ADV/DC/PAGE 1----------------
choose category
ADV BAT SHUNT PG2