Outback Power Systems GVFX Series Inverter/Charger Programing Manual - Manual (Page 49)

47
• With the programming completed, turn the AC
output breakers ON with the AC BYPASS on the AC
breaker panel switched to NORMAL.
Verify the AC voltage output through the MATE following path:
PATH
MAIN------- SETUP------------ STATUS/FX/PAGE1---------- Invert Bulk P00 STATUS/FX/METER--P00
12.15:30p choose device: choose category: inv 0.0Kw zer 0.0kw output 127 vac
chg 0.0kw buy 0.0kw voltage
SUM STATUS SETUP ADV FX CC DC MAIN MODES METER BATT PG2 DOWN STATUS PORT DOWN UP TOP PORT
Note: If you are using the FW-X240 Auto Transformer for step-up functioning, turn on its breaker now.
Otherwise, go to the next step.
BYPASS OUTPUT INPUT
AC ON