Outback Power Systems GVFX Series Inverter/Charger Programing Manual - Manual (Page 47)

45
3P CLASSIC B
• Make sure the two slave inverters are in Ports 02 and 03 of the HUB. The inverter on HUB Port 2 is
considered phase B. The inverter on HUB Port 3 is considered phase C.
ADV/FX/STACK----------P01
stack Master
phase
DOWN INC DEC PORT
• From the Master screen, press the soft key
until P02 appears.
ADV/FX/STACK-----------P02
stack Master
phase
DOWN INC DEC PORT
• Each new Port screen in the stacking menu will
open with Master displayed. To change the stacking
designation, press the soft key until 3p Classic
B appears.
ADV/FX/STACK----------P02
stack 3p Classic B
phase
DOWN INC DEC PORT
• After establishing P02 as a 3p Classic B, press the
soft key to switch to P03.
ADV/FX/STACK----------P03
stack Master
phase
DOWN INC DEC PORT
• As before, P03 will open with Master displayed.
Press the soft key until 3p Classic C appears.
ADV/FX/STACK----------P03
stack 3p Classic C
phase
DOWN INC DEC PORT
• Press the Press the soft key when finished.
This will allow you to observe the power save levels,
or exit the menu.