Monoprice 8744 PoE Wireless Access Point - Manual (Page 19)

19

AP MAC Address:
Input the remote AP’s MAC address. (No more
than 4)

Channel: Select the channel which bridge needs to use. (All APs
in the bridge must be at the same channel.)

Enable Scan: Click this button, the AP will scan the nearby
wireless devices automatically and display the information in the
table. Select the device which need to bridge, the AP will add the
device’s MAC address automatically and select the corresponding
channel. When multiple devices are added, AP will select the
channel of the last added device as the bridge used channel (You
can also change the channel according to your need. All the
devices must at the same channel, thus the bridge can be
established.)