Monoprice 8744 PoE Wireless Access Point - Manual (Page 10)

10
Users can select the mode according to need. Please refer to Chapter
4.1.2 for detailed introduction.
Click “Enable Scan”. AP will scan the available wireless device nearby
automatically and display them under the list (see the picture below).
Select the AP which you need to bridge and click “Next” to enter the
security setup interface. On the other hand, you can input the MAC
address of wireless device which you want to bridge manually and
select the corresponding channel.
After finish the settings, click “Next” to enter the “Security Setting” option
as the picture below.