Monoprice 8744 PoE Wireless Access Point - Manual (Page 16)

16
wireless client to recognize wireless signals.

Broadcast SSID: When you s
elect “Disable SSID broadcast”, AP
will not broadcast its own SSID number. If there is a wireless
connection request, you need to input SSID number manually.

BSSID
：
Basic Service Set Identifier of wireless network. In
IEEE802.11, BSSID is the MAC address of wireless access point.

WLAN Isolation: The access control feature based on wireless
MAC address. When this feature is enabled, each of your wireless
clients will be in its own virtual network and will not be able to
communicate with each other. This feature is to isolate the
communication of wireless clients connected with different AP.

Channel
：
Specify the effective channel (from 1 to 13\Auto) of the
wireless network.

Extension channel
：
To increase data throughput of wireless
network, the extension channel range is used in 11n mode.

Channel Bandwidth: Select the proper channel bandwidth to
improve the wireless performance. 20M bandwidth can improve
the anti-jamming ability of the wireless device. 40M bandwidth can
improve the flux of 11N client.
4.1.2 Bridge (WDS) Mode
Bridge (WDS) mode includes P2P, P2MP, Wireless Repeater.
4.1.2.1 Point to Point Bridge
P2P bridge mode can connect with two wired network via wireless
access points, which communicate by wireless signals and not by
cables. This mode can be free from the cable trouble. The P2P topology
shows below