GReddy TURBO KITS: Nissan 370Z 2009- / twin TD06SH-20G User Manual

Page 17

―１７―

-12 Waste Gate Installation

12 Waste Gate Installation

Install the provided banjo fitting on to the bottom port of the waste gate. (top port is used for boost

controller) Install the waste gate and waste gate inlet pipe using the provided gaskets and hardware

as shown.

(Part Used #4, 9,

10, 85)

Left Side (Driver’s Side)

Right Side (Passenger’s Side)

•

Recheck the clearance between the waste gate and the main engine harness on the right side

(passenger side). Verify that there is enough clearance to avoid direct contact from heat to
avoid any possible damage.

•

Install the waste gate open pipe and waste

gate bracket using the provided gaskets
and hardware as shown.

(Part Used #11, 12, 13, 14, 15, 82, 83)

-13

13 Waste Gate Vacuum Line installation

Waste Gate Vacuum Line installation

Cut the master power vacuum hose by the

intake manifold and install the 3way fitting.

Connect the 6Φside to the waste gate fitting

with the provided 6ΦHose.

*Secure all the vacuum hose with zip ties to

prevent the hose from coming off the fitting.

(Part Used #43, 75, 76, 77)