GReddy TURBO KITS: Scion xB 2003-05 / TF03-14G - Manual (Page 15)

3 33 3－ － － －1 11 14 44 4 E E E E- -- -manage Installation manage Installation manage Installation manage Installation
（1）Remove the cover under the glove box to access the ECU and ECU harness. Unplug the ECU connectors
from the ECU.
（2）Connect the provided Plug and Play e-manage harness to the ECU and ECU harness. Connect the
e-manage unit to the Plug and Play Harness.
〈Parts№34,35〉
(5)Secure the e-Manage next to the ECU.
* Avoid mounting the e-Manage unit in the area that would be exposed to direct sun light,
moisture, or near heater outlet.
3 33 3- -- -1 11 15 55 5 Starting the Engine Starting the Engine Starting the Engine Starting the Engine
(1) Refill the engine oil to factory spec.
(2) Check all the hoses and wires connection, then reconnect the negative side of the battery.
(4) Remove the ECM fuse and crank the engine to get oil pressure to the turbo. (Until the oil light
on the dash turns off) Check for any oil leaks, then reinstall the fuse and start the engine.
(5) While idling, check for any oil, coolant, or air leaks.
(6) After inspection, reinstall the under cover and other stock parts that were removed.
(7) On the initial run, be sure to have a boost gauge to check the turbo-actuator setting. This turbo
kit is preset to boost between 0.3kg/cm 2 to 0.4kg/cm 2 .
It is very important that you monitor the boost pressure, and make sure not to over boost. Over
boosting can cause engine damage.
This completes the Turbo Kit installation.