DAVIS DriveRight Installation - VSS (8156, 8160) - Manual (Page 11)

3URFHGXUH )LQLVK WKH ,QVWDOODWLRQ
Use the following steps to finish the installation.
I‚‡r) It is not necessary to enter a code in order to perform this test. Do not enter a code until
you read the user’s manual.
D†‡hyyÃ7h‡‡r ’
Insert the battery into the
DriveRight console as shown.
8‚rp‡Ã8‚†‚yrГ‡‚Г6qhƒ‡r Ã8hiyr
Connect the adapter cable to the console cable.
It is easiest to make the connection by first holding the adapter cable by the
connector housing and holding the console cable by the cable itself next to
the sliding connector housing.
! Push the two connectors together. The connector housing on the console
cable slides back when you make the connection, allowing the cables to lock
together.
I‚‡r) To disconnect the cables, hold both cables by the connector housing and pull apart. The
sliding housing on the console cable connector will release the lock and allow the cables
to be separated.
" Once plugged in, the console should “wake-up” into the Current Readings
screen. If the display remains blank, make sure the battery is properly
installed in the unit. If it is, try pressing MODE. If the screen remains blank
after pressing MODE, press both the MODE and PLUS simultaneously. If it
remains blank after that, check the adapter cable and harness cable
connections.
Sliding
Connector
Housing
Console Cable Adapter Cable
To Connect Cables,
Hold as Shown Here
07395.062 Rev E Body D121.fm Page 9 Monday, December 1, 2003 10:52 AM