Anthem AVM 30 - Manual (Page 37)

Program Preset Selections
• 2.0 For stereo input, select any Mode in section 4.8.3, THX Games Mode, or Last Used. Dolby
Pro Logic, Pro Logic IIx Movie, and Neo:6 Cinema can be set with or without THX Cinema.
The following presets apply to Digital inputs only:
• 2.0-Sur Separate setting especially for surround-flagged Dolby Digital 2.0 material (section 4.8.2),
normally PLIIx Movie but any setting that applies to regular stereo input can also be used.
• DD-5.1 Select your playback preference for Dolby Digital 5.1 material: PLIIx Movie (either with or
without THX Cinema), PLIIx Music, Dolby D EX, THX Surround EX, THX Cinema,
THX Ultra2 Cinema, THX MusicMode, THX Games Mode, Neo:6 (either with or without
THX Cinema), Last Used, or None (see sections 4.8.4 and 4.8.6).
• DD-EX For material encoded in Dolby Digital Surround EX: PLIIx Movie (either with or without
THX Cinema), PLIIx Music, Dolby D EX, THX Surround EX, Neo:6 (either with or without
THX Cinema), Same as DD-5.1, Last Used, or None (see sections 4.8.4 and 4.8.6)
• DTS-5.1 For DTS material: Neo:6 (with or without THX Cinema), PLIIx Movie (either with or without
THX Cinema), PLIIx Music, Dolby D EX, THX Cinema, THX Ultra2 Cinema, THX MusicMode,
THX Games Mode, Last Used, or None (sections 4.8.5 and 4.8.6).
• DTS-ES For DTS-ES: DTS-ES Matrix (with or without THX Cinema), PLIIx Movie (with or without
THX Cinema), PLIIx Music, Dolby D EX, Same as DTS, Last Used, or None (see sections
4.8.5 and 4.8.6). Note that for ES Discrete, this setting is overridden and playback is in 6.1.
29
3. SETUP MENU
continued …
Speaker Configuration (MAIN only):
Choose between Cinema or Music configuration (section 3.2), or Auto-LFE. When this is selected, the AVM
30 uses the Cinema configuration if there is LFE in the source material, and changes to the Music
configuration at all other times. Auto-LFE is recommended when using the same player for DVDs and CDs,
and separate Cinema and Music configurations.
Component Video Input:
Assign which video input (or ‘None’) is used for video switching when the Source is selected.
Lip-Sync Delay (MAIN only):
Video can fall out of synchronization with audio for a variety of reasons. If for whatever reason audio is heard
before the corresponding image is seen, you can set up to 85 milliseconds of audio delay. You can also set
delay while watching video – see section 4.9.
Mode Presets (MAIN only):
When you or another member of your family uses the AVM 30, the Mode and THX presets that are set here
are recalled, ensuring trouble-free operation. The presets are applied whenever a Source is selected or
MAIN power is turned on. Each type of program material has a separate setting. Presets do not apply to
Sources that are set to Anlg-Dir. If you do not want to have presets, set this to ‘Last Used’.
Use the buttons to highlight one of the lines in the menu, then use the buttons to scroll through the
selections. For complete descriptions of surround modes and when to use them, refer to section 4.8.