Turbo Action 70600 CHEETAH E-SHIFT Controller - Manual (Page 5)

5
Figure #1
CHEETAH E-SHIFT Controller
#70600
NOTE: The terminal block containing the 1-4 shift outputs also has one input which
can be 12-16 Volts (The preferred way to wire up shift devices.) or a ground
(
Dangerous way to wire shift devices. ) depending on the device you are trying to
activate. This power source passes directly to the outputs when the controller
activates the appropriate relay or relays. We suggest 12-16V power be supplied
to the device from your CHEETAH E-SHIFT Controller and have your solenoid or
light grounded at its location. Note: Some Electric Shifters such as Dedenbear,
Biondo, Etc. require a high current relay Turbo Action Part #5000-1. See Fig. #4.
Shift Lights
Digital Display
1000’s Set 100’s Set
Time Select Time Set
Function
Switch
Reset
Switch
Terminal Block
Inputs
Terminal Block
Outputs/Input
6 5 0 0
12-16V Ground T
ach Input
Burnout/linelock Pit Road T
ranz Brake/Clutch
4th Shift Out 3rd Shift Out 2nd Shift Out 1st Shift Out 12-16V Input (See note below)
1 2 3 4 5 6 5 4 3 2 1
9/19/14
12-16V must be connected
to battery, no switch in
between!
Ground must be connected
to same location that the
car ignition gets its ground!