Turbo Action 27253 Turbo Hydro 200 Manual Valve Body (PRN321) User Manual

Turbo Action For the car

Part # 27253

2/14/08

1535 Owens Road, Jacksonville, FL 32218

Phone 904-741-4850 * Fax 904-741-4853

FIRST, READ INSTRUCTIONS CAREFULLY, THEN PROCEED TO INSTALL VALVE BODY BY FOLLOWING
EACH STEP INDIVIDUALLY.

CAUTION:

Working on this transmission will require the use of metric tools.
The following tools and items will be required:

Screwdriver

Rachet and 3” Extension

13mm Socket (sometimes 1/2” will work)

10mm Socket
Name Brand Type “F” or Dexron Transmission Fluid (Number of Qts. will
vary depending on the size of your torque converter).

Kit Includes:

1 - 27253

Valve Body

1 - 27088-2 Special Valve Body Plate
1 - 27099C

Pan Gasket

1 - 27097

Spacer Plate to Valve Body Gasket (Marked V.B.)

1 - 27098

Spacer Plate to Case Gasket (Marked C)

1 - 27103

Filter Gasket

1 - 23138

Set Screw (3/8”-16 x 5/16”)

1 - 24126

Set Screw (5/16”-18 x 1/4”)

2 - 50093

Contingency Decals

This Valve Body can be installed while in the car, however, for maximum durability and performance we
suggest taking the transmission apart. See Optional Steps section. Steps #12 thru #15.

STEP #1:

Transmission should be cool before installing the Valve Body. Also, place gear shift selector in
park. If vehicle is on the ground, secure so it will not roll.

STEP #2:

Drain transmission by dropping pan at one end. Recommend leaving a couple of bolts at-
tached until most of the oil has drained (bolts 13mm).

STEP #3:

Remove transmission oil filter by removing two bolts (10mm socket). Also, these two bolts
are longer than other valve body bolts. (Fig. #2)

STEP #4:

Being very careful, remove bolt which holds throttle lever and bracket assembly. See Fig. #3.
You will no longer need the throttle lever and bracket assembly.

STEP #5:

Remove bolt holding manual detent roller and spring. See Fig. #4.

CHEETAH Competition Manual Valve Body - (PRN321)

Part #27253

Turbo Hydro 200 - 1976-Up