Turbo Action 24141 Turbo Hydro 400 Manual Valve Body (PRN123) User Manual

Cheetah manual valve body

Part #24141

1/78,6/99,3/03,3/06

1535 Owens Road, Jacksonville, FL 32218

Phone 904-741-4850 * Fax 904-741-4853

www.turboaction.com

Reverse Shift Pattern (PRN123)

No Engine Braking in 1st & 2nd

(Not for Street Application)

Turbo Hydro “400”

1965 – Up

Installation Instructions

FIRST, READ INSTRUCTIONS CAREFULLY, THEN PROCEED TO INSTALL VALVE BODY BY FOLLOWING EACH
STEP INDIVIDUALLY.

Valve Body

1 – 24141

Valve Body 1965-Up

Kit Includes:

1 – 24116

Special Valve Body Spacer Plate

2 – 24157

Special Valve Body Gaskets

1 – 24118

Expansion Plug (See STEP #12)

1 -

24148C Pan Gasket

STEP #1:

Transmission should be cool before installing. Be sure vehicle is secure to prevent rolling. Drain oil
by carefully removing pan bolts. Recommend leaving a couple of bolts partially attached until some
of the oil has drained.

STEP #2:

Remove transmission filter. If 1968 or newer model, hold pipe that filter is connected to so that it will
not come out when you pull filter off.

STEP #3:

Before loosening valve body, note how the gear selector lever connects to the manual control valve
in the valve body. Fig. #1

STEP #4:

Remove bolts from valve body and then carefully remove governor tubes and valve body together.
AVOID bending governor tubes. If 1970 or newer model, disconnect white wire from the valve body.
Also, be sure the manual control valve doesn’t slide out.

STEP #5:

Remove the two bolts holding the downshift solenoid and valve body spacer plate. Make sure you
support the spacer plate with your hand. Lower the plate with steel balls carefully.

STEP #6:

Remove intermediate front servo piston, washer, pin, retainer and spring from transmission case.
See Fig. #2 for location of your servo parts. They will no longer be used. OPTIONAL: If
transmission is out of car, remove intermediate (front) band.

STEP #7:

Remove rear servo. Discard inner accumulator piston oil seal rings. Fig. #3 & #4.

STEP #8:

Reinstall rear servo including accumulator piston and rear servo spring. Fig. #3.

STEP #9:

Remove manual control valve from old valve body and place into new valve body.

CHEETAH MANUAL VALVE BODY

Part #24141