ATI Technologies ALL-IN-WONDER X1800 - Manual (Page 13)

Quick Installation 5
CHAPTER 2:
Installing Hardware
This chapter will guide you through the physical installation of your new
All-in-Wonder® X1800 Series graphics card.
Quick Installation
For experienced users and system administrators, follow these brief
instructions for installing your All-In-Wonder® X1800 card in the shortest
possible time.
Installation Steps
1 Uninstall the drivers and software for your old graphics card.
2 Shut down and disconnect your computer system.
3 Remove any previously installed card.
4 Install your new All-In-Wonder® X1800 card.
5 Reassemble and connect your computer system.
6 Install the All-In-Wonder® X1800 drivers and configuration software
from the ATI Installation CD-ROM by doing one of the following:
• Run through the automatic ATISETUP utility; or
• Start > Run > X:\ATISETUP.EXE (where X is the drive letter
of your CD-ROM drive).
Detailed Installation
The following instructions will take you step by step through the
installation of your new All-In-Wonder® X1800.
L
If you are using a motherboard containing an on-board graphics
solution and do not intend to use it as part of a multiple monitor display,
disable it.