Ridetech 41190000 - Manual (Page 7)

Air Ride Technologies
Seat Back
Seat Belt
Retractor
Roof Bow
Trim Bezel
Headliner
Substrate
Re
ar
Torques
Head Bolt
Electrical
Connector
Lap Belt
Front
5
41190000
74-81 Camaro TigerCage
Main Hoop Installation
Step 6. Disconnect the electrical connector
from the seat belt sensor. Using a T45 torques
wrench or socket remove the toques head bolt
securing the front seat lap belt to the floor pan.
Do both the driver and passenger sides
(See Fig 8).
NOTE: You will be unable to reuse the factory
seat belt shoulder harnesses and trim bzels.
New bezels will need to be fabricated to close
out the hole in the headliner substrate. A four
or five point harness must be used with the
Tiger Cage for driver and passenger restraint
Step 5. If your car is equipped with factory
installed seat belt shoulder harnesses, remove
the two screws attaching the trim bezel to the
seat belt retractor (See Fig 7). Next remove
the two screws attaching the seat belt retractor
to the roof bow.
Step . Remove the screw and washer at the
bottom of the seat back on both the driver and
passenger side and retain for reinstallation
(See Fig 6). Pull the bottom of the seat back
out and push in at the top while lifting up to
remove the seat back.
Fig 6
Fig 7
Fig 8