ididit Cable Shift Linkage Kit: Ford Column to Ford AOD Transmission - Manual (Page 3)

Legend:
Numbers 1-8 are on this diagram
1.) Shift Lever
2.) Throttle Lever
3.) Oil Filter (Not pictured)
4.) Detent Spring
5.) Shift Lever Retaining Pin
6.) Inner Throttle Lever
7.) Inner Shift Lever
8.) Park Operating Rod
Numbers 9-12 are on Page 1
9.) Cable Bracket
10.) Spacer
11.) Cable Boots
12.) Cable Nut & Lock Washer
1. Jack the car up to a convenient working height and place jack stands
under the frame. Never work under a car that is only supported by a
jack, always use jack stands or other supports.
2. Place a drain pan under the transmission. Starting at the rear of the
pan working towards the front, loosen the pan bolts and allow the fluid
to drain. Remove the pan and gasket. Scrape the remaining gasket
material off the oil pan and then transmission case.
3. Disconnect the shift linkage from the transmission shift lever (1).
Remove the 13mm nut that secures the throttle linkage lever (2) and
remove the arm from the transmission. Let the arm hang loose on the
linkage.
5
6
7
1 2
4
8
2