ididit Cable Shift Linkage Kit: Ford Column to Ford C-6 Transmission - Manual (Page 5)

12. On the C-6 transmission you
must cut off the original shift
lever on the transmission.
Note: Once you cut the old
shift lever off, there is no
turning back! Remove the
two pan bolts marked with
x’s. Also remove the nut and
washer from the kick down lever and then remove the kick down lever
itself.
13. Spacers need to be placed between the
bracket and transmission pan with the
two bolts supplied in the kit holding it
all together in the holes of the bracket
shown.
14. Make sure that the transmission is in Park. Install the transmission
shift lever using the nut and bolt supplied. Note that it covers the
original shift lever previously cut off. Now install the kick down lever
with the original nut and washer.
15. Take the small nut, two rubber boots, and one large nut and washer
off the transmission end of the cable. Insert the cable into the bracket.
Reinstall the large washer and nut and the two boots. (continued on
next page).
4