beautypg.com

ididit Cable Shift Linkage Kit: Ford Column to Ford C-6 Transmission User Manual

Page 4

background image

7. Reinstall the horseshoe bracket. It can either

go on the top side of the column or below, it is

your choice. Check for any brake pedal inter-

ference.

8. The cable is the next

piece that you are looking

for. Notice that both ends

are the same. We did that so

you could be right the first

time. You will need to take the small nut and the

rubber boots off so that you can get one large nut

and washer off. Put the cable through the bracket

from the bottom side of the bracket and reinstall the large nut, washer,

and boots. Try to center the nuts and washers on the available threads.

This is important later.

9. Push the cable down through its outer cover so that it will be as short

as possible. Put the column in Park. Now, figure out where you want

the bracket to be, 5 o’clock will probably be a good place. Install the

swivel on the small thread and turn it until it is centered on the thread.

Now, install the small nut and turn it until it bottoms out on the swivel.

Do not tighten yet.

10. Rotate the bracket until the swivel drops into the

5/16” single hole 2” from the center of the main

shaft. If the bracket hits something or is in a bad

place, you can use another set of holes in the

horseshoe bracket, move the swivel up or down

its thread length, or move the cable on its length

of threads. Always remember that the cable that

moves must be pushed in all the way. Tighten the

bracket onto the tube.

11. Route the cable towards the rear of the vehicle

and then turn it in a nice U shape. Stay away from exhaust pipes! If

this cable gets too close, it will melt and not work at all. This is a very

important step.

3