ididit Cable Shift Linkage Kit: Column to GM Transmission - Manual (Page 2)

Before installation please read:
You will need at least 2” of clearance between the firewall and
lower shift lever for this product to function correctly.
Melted Cables: If your cable is too close to your exhaust it will melt or
become brittle. If this is the case you will need to make a heat shield. Do
not wrap the cable as this retains heat. Heat will destroy the cable.
Kinked Cables: Do not kink the cable anywhere along its length. If the
cable has a kink it will lock up. The cable should be kept straight for 2”
on each end where it leaves the bracket. Either of the above could damage
the cable, shifter, and/or transmission in one shift.
Your kit should contain the following parts:
A.) Transmission Lever
B.) Pan Bracket
C.) Spacers
D.) Cotter Pins
E.) Swivels
F.) Shift Cable
G.) Horseshoe Bracket
H.) Two Piece Bracket
A.
C.
B.
D.
E.
G.
H.
1
2 Transmission pan bolts are required. They will need to be 1/4”
longer than the stock bolts. You will need to purchase these after
determining whether you need Metric or American.
ididit Column to 350 Trans