ididit Retrofit Steering Column: 1976-86 Jeep CJ5 & CJ7 - Manual (Page 7)

We want to install the dash mount and floor mount loosely until both are installed.
Then, draw the dash mount up tight at 42 ft. lbs. Now you can tighten the two lower
nuts on the floor mount to 22 ft. lbs., the vertical bolts to 22 ft. lbs. and then the upper
bolts to 22 ft.lbs. This sequence allows the column and mount to draw down properly
with the gasket. (See Figures 14 & 15)
The dash bezel is next. Install the 4 screws for this cover. Note the column and cover
should be centered on each other. If necessary, the column bolts could be loosened
and shifted a little either way. Make sure you re-tighten these if you move the column.
(See Figure 16)
(Figure 14) (Figure 15)
(Figure 16)
Now you can follow the instructions
for the Dress up Kit for the levers and
knobs.
6