Alpine VPA-B222R - Manual (Page 32)

31
-EN
01GB05VPAB222R.fm
ALPINE VPA-B222R 68-02065Z87-A (EN)
Operating Factory System (Speaker
Input mode)
The car’s system (standard CD player, etc.) can be selected as a source.
1
Press SOURCE/POWER.
The source selection screen is displayed.
2
Press the joystick up or down to select the
FACTORY SYS mode, then press
/ /ENTER.
The speaker input screen is displayed.
• FACTORY SYS mode is displayed when SOURCE or BOTH is set in
"Setting the Speaker Input Mode" (page 16).
• Make each setting correctly in “Using the Speaker Input” (page 16)
before use this function.
When an external audio processor is connected to this unit, you can
operate it from this unit. Some audio processors may not be operated.
Explanations below is the case when PXA-H700 or PXA-H701 is
connected for example.
Refer also to the operating instructions of the connected audio
processor.
• The adjustments or settings performed on the connected audio
processor cannot be operated properly from this unit.
• The setting "Setting the Speakers", "Setting Bass Sound Control",
and "Graphic Equalizer Adjustments" are not available if the MRD-
D550 is connected. Additionally, if the MRD-F350 is connected, the
following setting "Setting the MX mode" is not available. Also, the
setting content differs between the PXA-H700 and PXA-H701.
Factory System External Audio
Processor
(Optional)
Joystick
01GB00VPAB222R.book Page 31 Monday, January 23, 2006 4:24 AM