Alpine VPA-B222R - Manual (Page 14)

13
-EN
01GB05VPAB222R.fm
ALPINE VPA-B222R 68-02065Z87-A (EN)
For remote control operation, the remote sensor of the external device
(monitor, etc.) can be switched, as you prefer.
Switching the Remote Control Sensor
1
In the SETUP screen mode, press the joystick up or
down to select SYSTEM SETUP, then press the
joystick right.
The SYSTEM SETUP screen is displayed.
2
Press the joystick up or down to select REMOTE
SEL.
3
Press the joystick left or right to select the monitor
to be controlled by the remote control.
4
Press TA/RTN/SETUP to return to the previous
screen. Press TA/RTN/SETUP repeatedly to return
to the main source screen displayed before starting
the setup operation.
• Select SETUP on the FUNCTION screen to recall the SETUP screen
after pressing and holding /MENU/FUNC. for at least 2 seconds.
• The sensor of the touch panel rear monitor has priority over the
sensor of the remote control, if the rear monitor (connected to the
Alpine touch panel rear monitor via the Monitor control lead) is
touched, regardless of the remote control sensor switch setting. Note,
however, that the sensor of the remote control that has been set takes
priority if it has been 5 seconds since last touching the panel.
General Setup Operation
1
Press and hold TA/RTN/SETUP for at least 2
seconds.
The SETUP screen is displayed.
Switching the function of the remote
sensor
FRONT: Remote control operation can be performed
when the Alpine monitor is connected using an
RGB cable, and also when a monitor (other
than Alpine) connected to a remote control
sensor unit (optional) is connected.
REAR-1: The remote sensor of the external monitor
connected to AUX OUT1 of the tuner box of this
unit, or the optional expansion box (VPE-S431)
is effective, and the remote control can operate
only the source selected for the REAR SELECT
screen.
REAR-2: The remote sensor of the external monitor
connected to AUX OUT2 of the optional
expansion box (VPE-S431) is effective, and the
remote control can operate only the source
selected for the REAR SELECT screen.
Setup
GENERAL Setup
The Parking Brake must be engaged to access the SETUP
mode screen. Attempting to access this screen while driving
will display the warning-CAN’T OPERATE WHILE DRIVING.
The following steps 1 to 5 are common operations to each
“Setting item” of GENERAL Setup. Refer to each section for
details.
Joystick
01GB00VPAB222R.book Page 13 Monday, January 23, 2006 4:24 AM