Marvell – Asus MOTHERBOARD P5N64 WS User Manual
Page 53
ASUS P5N64 WS Professional
2-27
4. Marvell
®
88SE6320 SAS RAID connectors [yellow] (7-pin SAS1-2)
These connectors are for SAS (Serial Attached SCSI) signal cables that
support SAS hard disk drives. To configure RAID 0 or RAID 1, install two SAS
hard disk drives to these two connectors.
Before creating a RAID set using SAS hard disk drives, make sure that you
have connected the SAS signal cables and installed SAS hard disk drives;
otherwise, you cannot enter the Marvell RAID utility and SAS BIOS setup during
POST.
P5N64 WS PRO
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SAS1
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SAS2
P5N64 WS Professional SAS connectors
• Please install the Marvell
®
Controller driver before using the yellow SAS
RAID connectors (SAS1-2). Refer to 5.2.4 Make Disk menu for details.
• Before creating a RAID set, refer to 5.4.4 Marvell
®
SAS RAID
configurations or the manual bundled in the motherboard support DVD.