Asus MOTHERBOARD P5N64 WS - Manual (Page 156)

5-48 Chapter 5: Software support
5.4.3 Marvell ® eSATA RAID configurations
The Marvell ® 88SE6121 external SATA controller allows you to configure RAID 0
and RAID 1 sets on the external SATA hard disk drives, or RAID 0, 1, 5 and 10
set(s) on external port-multiplier devices.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID
set(s). To do this:
1. Install two external Serial ATA hard disk drives to the external SATA ports
labeled ESATA1/2.
2. Boot up your computer, and press during POST to enter the BIOS
setup.
3. In the Advanced menu, go to Onboard Devices Configuration, and enable
both Marvell 6121/eSATA and 6121 Boot ROM.
4. Set the Marvell 6121/eSATA item to [RAID].
5. Press to save the changes and exit.
The RAID BIOS setup screens shown in this section are for reference only, and
may not exactly match the items on your screen.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2008, American Megatrends, Inc.
Onboard Device Configuraiton
High Definition Audio [Enabled]
OnChip LAN1 [Auto]
OnChip LAN2 [Auto]
LAN Boot ROM [Disabled]
Marvell 6121/eSATA [Legacy Mode]
6121 Boot ROM [Enabled]
Marvell 6320/SAS [Enabled]
6320 Boot ROM [Enabled]
Onboard 1394 [Enabled]
Serial Port1 Address [3F8/IRQ4]
Enable or Disable
High Definition Audio
Controller
BIOS SETUP UTILITY
Advanced