beautypg.com

Audio 2, 4, 6, or 8-channel configuration – Asus MOTHERBOARD P5N64 WS User Manual

Page 48

background image

2-22

Chapter 2: Hardware information

10. Wireless LAN ports. These ports are on the onboard wireless LAN module

that allow you to set up a wireless network and exchange information

with other wireless devices without tagling cables and wires. Connect the

moveable omni-directional antennas to these ports.

11. Wireless LAN Activity LED. The wireless module comes with an activity

LED.

12. Microphone port (pink). This port connects a microphone.
13. Side Speaker Out port (gray). This port connects the side speakers in an

8-channel audio configuration.

14. USB 2.0 ports 1 and 2. These two 4-pin Universal Serial Bus (USB) ports

are available for connecting USB 2.0 devices.

15. External SATA ports. These ports connect to external Serial ATA hard disk

drives. To configure a RAID 0, 1, 5 or 10 set, install two external Serial ATA

hard disk drives or the port-multiplier device to these ports.

Refer to the audio configuration table below for the function of the audio ports in

2, 4, 6, or 8-channel configuration.

Audio 2, 4, 6, or 8-channel configuration

Port

Headset

2-channel 4-channel

6-channel

8-channel

Light Blue Line In

Line In

Line In

Line In

Lime

Line Out

Front Speaker Out Front Speaker Out

Front Speaker Out

Pink

Mic In

Mic In

Mic In

Mic In

Orange

Center/Subwoofer

Center/Subwoofer

Black

Rear Speaker Out

Rear Speaker Ou

Rear Speaker Out

Gray

Side Speaker Out

• Before creating a RAID set using external Serial ATA hard disks, make

sure that you have connected the external Serial ATA signal cables and

installed external Serial ATA hard disk drives; otherwise, you cannot enter

the Marvell RAID utility during POST.

• If you intend to create a RAID set using the external SATA ports, set

the Marvell 6121/eSATA item in the BIOS to [RAID Mode]. See section

4.5.4 OnBoard Device Configuration and 5.4.3 Marvell

®

eSATA RAID

configurations for details.

• DO NOT insert different connectors to these ports.
• DO NOT unplug the external Serial ATA drives when a RAID set is

configured.

This manual is related to the following products: