American Fibertek SMH10p-PoE - Manual (Page 154)

145
switch(config-if)#no event smtp
show systemlog P Show system log
client & server
information
switch#show systemlog
SNTP Commands Set
Netstar Commands Level Description Example
sntp enable G Enable SNTP function switch(config)#sntp enable
sntp daylight G Enable daylight saving
time, if SNTP function
is inactive, this
command can’t be
applied.
switch(config)#sntp daylight
sntp daylight-period
[Start time] [End time]
G Set period of daylight
saving time, if SNTP
function is inactive,
this command can’t be
applied.
Parameter format:
[yyyymmdd-hh:mm]
switch(config)# sntp daylight-
period 20060101-01:01
20060202-01:01
sntp daylight-offset
[Minute]
G Set offset of daylight
saving time, if SNTP
function is inactive,
this command can’t be
applied.
switch(config)#sntp daylight-
offset 3
sntp ip
[IP]
G Set SNTP server IP, if
SNTP function is
inactive, this
command can’t be
applied.
switch(config)#sntp ip 192.169.1.1
sntp timezone
[Timezone]
G Set timezone index,
use “show sntp
timzezone” command
switch(config)#sntp timezone 22