American Fibertek SMH10p-PoE - Manual (Page 139)

130
comma(ex.2, 3, 6)
[Workport]: The
amount of work ports,
this value could not be
less than zero or be
large than the amount
of member ports.
aggregator group
[GroupID] [Port-list]
nolacp
G Assign a static trunk
group.
[GroupID] :1~3
[Port-list]:Member port
list, This parameter
could be a port
range(ex.1-4) or a port
list separate by a
comma(ex.2, 3, 6)
switch(config)#aggregator group
1 2-4 nolacp
or
switch(config)#aggregator group
1 3,1,2 nolacp
show aggregator P Show the information
of trunk group
switch#show aggregator 1
or
switch#show aggregator 2
or
switch#show aggregator 3
no aggregator lacp
[GroupID]
G Disable the LACP
function of trunk group
switch(config)#no aggreator lacp
1
no aggregator group
[GroupID]
G Remove a trunk group switch(config)#no aggreator
group 2
VLAN Commands Set
Netstar Commands Level Description Example
vlan database P Enter VLAN configure
mode
switch#vlan database
Vlanmode
[portbase| 802.1q |
V To set switch VLAN
mode.
switch(vlan)#vlanmode portbase
or